The Titan TTB280DRH is a 1700W concrete breaker, and like most corded breakers its motor runs on two carbon brushes. Brushes are designed to wear away over time. When they get short, the breaker loses power, sparks or cuts out. Fitting a new set is one of the cheapest repairs you can do on a breaker.
Signs the brushes are worn
- The breaker feels weaker and takes longer to break up concrete.
- Heavy sparking is visible through the motor vents.
- The motor cuts out, runs only in bursts, or needs the cable wiggled to start.
- A hot or burning smell from the motor end.
- The motor takes longer to stop when you let go of the trigger. Worn brushes reduce motor power and electric braking.
Which brushes fit the TTB280DRH
The TTB280DRH takes carbon brushes of about 6mm x 16mm x 22mm. Check the model number on the rating plate first (Titan model numbers start with TTB), then measure an old brush in mm to confirm. Our guide to reading your tool's rating plate shows where to look.
- Titan TTB280DRH breaker carbon brushes, pair: one replacement set.
- Titan TTB280DRH breaker carbon brushes, 4 pack: one set to fit and a spare set for next time.
How to replace the brushes
- Unplug the breaker and let it cool down.
- Find the brush caps or brush covers on the motor housing. Your manual shows where they are on your model.
- Remove the old brushes one at a time and note which way round each one sat.
- Compare the old brushes with the new ones. If the old ones are much shorter or chipped, they were the problem.
- Blow or brush out any carbon dust around the brush holders.
- Fit the new brushes the same way round, making sure they slide freely in their holders, then refit the caps or covers.
- Run the breaker without load for a few minutes so the new brushes bed in before heavy work.
Always replace both brushes together, even if only one looks worn, so the motor runs evenly.
If new brushes do not fix it
If the breaker still will not run properly with new brushes, the fault may be in the cable, switch or motor. Read how to tell when your carbon brushes need replacing for more on what brush wear looks like, and have the tool checked by a repairer if the brushes are not the cause.
Titan angle grinder brushes
We also stock carbon brushes for the Titan TTB283GRD 9 inch angle grinder in a 4 pack. For grinder symptoms, see angle grinder carbon brushes: symptoms and replacement.
Find your Titan brushes
All our Titan brushes are on the Titan carbon brushes page. For other brands, browse the full carbon brushes range or read how to identify the correct carbon brush for your power tool.